1.Cartridges and mouthpiece preparation:
*Ensure the cartridges and mouthpiece are clean and free from contaminants
*Remove the mouthpiece and set it aside in a safe location during the filling process.
2.Distillate preparation:
*If you're not adding Oil,Gently heat the distillate just enough to ease the filling process,ensuring it bellow 122°F(50°C).
*Choose high quality,food grade oil.
*Determine the desired ratio,typically between 1-5% of the total solution,a balanced start would be around 2-3%.
*After gently heating the distillate,integrate the oil,ensuring a consistent mix using a stirrer.
3.Filling the Cartridges:
*Utilize a syringe or filling gun,ensuring the needle's diameter is 1.6mm or less.
*Carefully fill between the glass wall and the center post,avoiding the introduction of distilate into the center post.
COMMON MISTAKE:
*Overfilling the cartridge can lead to malfunctions or leakage.Aim for a consistent fill without going beyond the cartridge's capacity.
4.Securing the mouthpiece:
*Reattach the mouthpiece to the cartridge within  1-2 minutes of filling.
*Ensure the mouthpiece is firmly in place but not overtightened.
COMMON   MISTAKE:
*Incorrectly threading or loosely attaching the mouthpiece can result in leaks or airflow complications.
5.Post-filling prot col:
*Turn the filled cartridge upside-down for 30 minutes.
*Afterward,revert to its upright position for an additional 30 minutes.This ensures an even distribution and proper coil saturation.
6.Storage and care:
*For optimal longevity,store filled cartridges upright in a controlled environment,ideally between 68°F(20°C)and 77°F(25°C).
*Treat cartridges with care to prevent any damage or unnecessary stress.
Attention:
Viscosity Issues:An inconsistent mixture,especially when adding oil,can alter the viscosity leading  to  potential leaks. Ensure thorough mixing.
Environmental concerns:Avoid exposing the cartridges to high temperatures,as this can make the distillate too runny,increasing leak risks.

1.The device comes with a battery/tank and a separate mouthpiece. Make sure to store the mouthpiece in a safe location while you are in the filling process.

2.Using a syringe, or other filling tools,fill the device by utilizing only one of the two outer filling holes. DO NOT FlLL CENTER HOLE. Be careful not to ill both outer holes at once as one is required to let air escape during the illing process.

3.Push the mouthpiece back on the device until it clicks into  place. Make sure to do this within 1 minute of filling the device.

AFTER FILLED

*Once the device is filled and the mouthpiece has been placed back on within 1 minute after filling, invert the device so that is upside down. This is to ensure the oil in the device cools away from the coil.This will help prevent any fracturing that might happen to the atomizer.

*After the device has been lipped upside down for 30 minutes, lip it right side up for another 30 minutes. This allows the oil to fully saturate the coil. lf the coil is not fully saturat- ed, then it can potentially cause dry hits.

*when you have completed the inverting process, simply store the device in a room-tem-perature environment with the temperature being between 68-77 degrees F.

ADDITIONAL INFORMATION

*Available in 1.0 ml

*The needle,s outer diameter must be = 1.8mm.

*Do not pre-heat oil higher than 122 degrees F.

*The coil begins to absorb up to around 30% of the tank size of oil. The oilvolume will be visually reduce and headspace will be formed.